EFEK VARIASI JENIS PEMBEBANAN DEFORMASI PLASTIS TERHADAP PERUBAHAN SIFAT MEKANIK DAN STRUKTUR MIKRO PLAT BAJA KARBON

Authors

  • Adri Fato Institut Sains and Teknologi Nasional
  • Margono Sugeng

DOI:

https://doi.org/10.54378/bt.v16i2.2181

Keywords:

Plastic deformation, Mechanical Properties, Drawing, Stamping, Curling

Abstract

Plastic deformation is a permanent deformation that occurs in steel, even though the load causing the deformation is removed. It is widely used to change the shape of steel permanently without adding or reducing the chemical composition of the steel. This permanent change in shape is followed by a change in the shape or phase of the microstructure of the steel. Several types of loading on plastic deformation are Pull (drawing), Stamping and Curling, which are widely used to change the shape of a plate to a curve or a circle.

References

William F, Hosford And Robert M. Caddell, METAL FORMING MECHANICS AND METALLURGY Third Editon,

Henry S. Valberg, APPLIED METAL FORMING Including Fem Analysis,

Nursidik: Analisis Sifat mekanik Baja pada bahan SPCC-HD dengan proses DEEP CURLING Dalam pembuatan Drum

MODLEN, G. (1990). Manufacturing Engineering and Technology. By Serope Kalpakjian. (Manufacturling Enggineering and Technology, Seveth Edition in S1Unites)

https://bektiwkidz.wordpress.com/2013/10/25/proses-pembentukan-logam-metal-forming/

www.ndeed.org/EducationResources/CommunityCollege/Materials/Mechanical/Mechanical.htm

https://fdokumen.com/document/proses-pembentukan-logam55b08922e7899.html

Downloads

Published

2021-03-30

Issue

Vol. 16 No. 2 (2020): Bina Teknika

Section

Articles

License

Journal Bina Teknika grants open acces to all of its content, based on that matter makes all research papers published are freely available to public which ensures greater global excchange of knowledge

  Creative Commons License

Journal Bina Teknika is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.

Refers to these license, all research papers agree to the following terms:

  • Attribution - Authors holds the credit of their research works published, in order to use materials from one or more research papers published in Bina Teknika should be given appropriate credit
  • Non Commercial - All research papers published in Bina Teknika may not use for commercial purposes
  • Share Alike - Any creation made under one or more concepts from research papers published in Bina Teknika should be distribute your contributions under the same license as original