PERENCANAAN PENGGUNAAN MATERIAL PLASTIK DAUR ULANG DENGAN SISTEM MANUFAKTUR BERKELANJUTAN DI POLITEKNIK MANUFAKTUR ASTRA

Authors

  • Komarudin Komarudin Program Studi Teknik Industri Fakultas Teknologi Industri Institut Sains dan Teknologi Nasional
  • Neilinda Novita Aisa Program Studi Teknik Industri Fakultas Teknologi Industri Institut Sains dan Teknologi Nasional

DOI:

https://doi.org/10.54378/bt.v11i2.102

Keywords:

Injection Process, ABS Material. Recycle, EOQ

Abstract

One of many kinds of production processes in Politeknik Manufaktur Astra is Plastic Injection Process with ABS material. This process will produce plastic and scrap. The amount of plastic scrap that is produced by this process reaches 50% of all of the amount. To increase the efficiency of ABS material and build up the culture of Sustainable Development System so that is done a kind of research that is focused on the utilization of plastic waste material from Process of Plastic Injection by doing a recycle process and using the product of recycle as the basic additive material in Plastic Injection Process. To figure out the properness of the material of recycled plastic as the main material in Plastic Injection Process so is also done a tensile test to any composition of recycled ABS material and valuing certain mechanical properties that are similar to original ABS material. Moreover to cut the cost of ABS material providing so is done an analysis of material reservation with EOQ method to figure out the economic number of material reservation. The calculation of EOQ showed the most economic amount per reserving is 75kg/reserve. By the utilization of recycled material and usage of EOQ method on providing the ABS material so that Politeknik Manufaktur Astra can do a cost reduction for 36%.

References

Haming, Murdifin dan Mahfud. (2012), Manajemen Produksi Modern Operasi Manufaktur dan Jasa Buku 2, Bumi Aksara, Jakarta.

Hartini,Sri dan Kadarsah. (2010), Teknik Mencapai Produksi Optimal, Lubuk Agung, Bandung.

Mitchell, Philip. Tool And Manufacturing Engineers Handbook Volume 8 Plastic Part Manufacturing, TMEH.

Smallmam, R. (1999), Metalurgi Fisik Modern dan Rekayasa Material, Terj. Modern Physical Metallurgy & Materials Engineering 6th Edition, Djaprie, Sriati (Pen.), Simarmata, Silvester

Lameda (Ed.), Erlangga, Jakarta.

Published

2017-08-02